Application Area
It is used on thinly plastered and properly made rough plastered surfaces in the facade jacketing system.
It is used as decorative coating on interior and exterior plasters.
Application Features
- Availability time max. 1 hour.
- Working time max. 30 minutes.
- Application thickness 2 mm.
Surface Preparation
- Do not apply on surfaces under direct sun or strong wind or hot surfaces.
- If there are defects on the application surface, they are corrected with repair / repair mortar.
- The surface should be cured and solid.
- If the application surfaces are porous, it should be wetted.
- Care must be taken to ensure that the application surface is in a solid carrier and also in its balance.
Application Conditions
- Ambient temperature is between +5°C and +35°C,
- Direct sun should not be applied under strong wind or on hot surfaces.
Warnings and Suggestions
- Foreign materials must not be added.
- All tools used should be washed with water before drying after the application.
Application Tools
Hand mixer, steel trowel, plastic trowel.
Application
- The container in which the mortar is to be prepared must be clean and free of any residual mix .
- Care should be taken to clean the water and materials used.
- The mortar should be prepared in 5-5.5 liters of water and 25 kg of MEGATECH DECORATIVE MINERAL PLASTER.
- First water is poured into the container and then the powder is added slowly. Mix until there are no lumps.
- In order to make the mixture homogeneous, a low speed mixer should be used.
- After obtaining a homogeneous mixture, rest for 5-10 minutes. It is mixed again for 1-2 minutes before starting the application.
- After the mixture becomes homogeneous, no powder, water or any other substance should be added.
- The prepared mortar is applied to the surface with a steel trowel at the fill size and the surface is textured by making circular movements with a plastic trowel.
- The prepared mortar should be consumed within 1 hour.
- Application should be done in one go on the surfaces that are connected to each other.
- It cannot be left on the surface as the last layer building material. It must be painted over after drying.
- Application should not be performed in cases where the temperature may fall below +5°C within 24 hours following the application.
- Extremely hot surfaces should be moistened before application.
- Paper tapes should be used to ensure that joints are not visible on large surfaces and work loops, or a sufficient amount of applicators should be used to ensure wet application before age, without drying the material.
- The material should not be used on horizontal surfaces exposed to rain.
- Expired or crusted mortar in the container should be discarded.
- Hands and application tools should be washed with plenty of water after the application.
Consumption
Approx.2.4-2.8 kg / m2 (for 2 mm thickness).
Performance Information
- Dry film Thickness: E5
- Grain Size Class: S4
- Water Vapor Transfer Rate: V2
- Water Transfer Rate: W3
- Crack Covering Feature: A0
- CO2 Transmittance: C0
- The application features have been determined in consequence of the tests conducted in laboratory environment (23 ± 2 0 C and 50% ± 5 humidity, and no air current), and thus, they may vary by differen ambient conditions. The performance details have been tested in the ambients specified in accordance with the relevant standard of the product, and different results may be observed in different ambients.
Reference Standards
- TS 7847.
- G.
- Public Works Pos No: 04.476 / A.
Packaging
- In 25 kg craft bag,
- 64 in pallet, 1600 kg
Physical State
White, powder.
