MegaBlock Thermal Plaster

Cement-based, high adhesion Megablock Thermal Plaster with strengthened bonding adherence.

The container in which the mortar will be prepared must be clean and clear of the remnants of the previous mixture.
Attention should be paid to the cleanliness of the water and materials used.
The mortar should be prepared at the rate of 15 kg Megablock Plaster Mortar in 6-6.5 liters of water.
First water is poured into the container and then the powder is sprinkled slowly. It is mixed until a homogeneous mixture is obtained.
A low-speed mixer should be used for the mixture to become homogeneous.
After obtaining a homogeneous mixture, it is rested for 5-10 minutes for the mortar to mature.
It should be mixed again for 1-2 minutes before starting the application
After the mixture becomes homogeneous, absolutely no powder, water, or any other substance should be added.
The mortar is applied to the application surface with a steel trowel and plaster shovel. After 5-10 minutes, gauging is done.
When the plaster does not move when touched with a finger, a trowel correction is performed.
Approximately 30 minutes after the correction process, the surface is slightly wetted, sponge trifoliate is made and the process is finished. In terms of the strength of the plaster, the surfaces should be watered at regular intervals depending on the ambient conditions within 7 days after the application.
The prepared mortar must be consumed within 2 hours.
Expired or crusted mortar in the container should be discarded.
After the application, hands and application tools should be washed with plenty of water.

2-4cm Thickness	2 Layers of Application	1.Floor: 1-2cm 2.Floor: Total Required
4-6cm Thickness	3 Layers of Application	1.Floor: 1-2cm 2.Floor: 1-2cm 3.Floor: Total Required
6-8cm Thickness	3 Layers of Application	1.Floor: 1-2cm 2.Floor: 1-2cm 3.Floor: Total Required